Description

Compression Tap Connector H-Shaped

Description of Compression Tap Connector H-Shaped

Compression Tap Connector H-Shaped is made of electrical conductor-grade soft aluminum for all connection combinations of Al-Al or Al-Cu conductors or pure electrolytic copper for Cu-Cu connections

There is an A groove and a B groove which could accommodate the same conductor sizes, or the A groove would be larger (line-side) and the B groove would be smaller (tap-side)

The fold-over tabs on each side e.g. A can be tapped over to hold the H type compression connector on the line without falling off and B can be tapped over to hold the tap wire in place before continuing with the installation

Models		CRH-11	CRH-22	CRH-41	CRH-21	CRH-31	CRH-32
Outer Dimater	Run “A” (mm)	4.8-8.2	10.0-14.0	16.2-22.4	8.3-14.0	13.0-22.4	13.0-22.4
	Run “B” (mm)	4.8-8.2	10.0-14.0	16.2-22.4	4.8-9.6	4.8-11.4	11.6-16.0
Conductor Size	Run “A” (mm²)	16-35	50-95	150-240	50-95	95-240	95-240
	Run “B” (mm²)	16-35	50-95	150-240	16-50	16-70	70-150
Insulate Sleeve’s Models	Plastic Type	JH-1	JH-2	JH-3	JH-2	JH-2	JH-2
	Rubber Type	LHZ-1	LHZ-2	LHZ-3	LHZ-2	LHZ-2	LHZ-2

H Shaped Aluminum Connector can connect two wires of equal diameter and different diameter. The span of wires in the same slot is generally 3-4 specifications. When the H-shaped parallel groove clamp is connected to the wire, due to the ring force, the aluminum on the inner wall of the clamp is plastically deformed, and it is embedded in the twisted gap of the outer layer of the wire, and the effective contact surface is large. The H-shaped parallel groove clamp pairs the wire The grip strength is about 40%-65% of the calculated breaking force of the wire.